10-20-2016 06:46 PM
Here is my situation:
Have a server (server name = apollo-2016) connected to a private network with an internal IP . The server is routed to an external IP ( 188.8.131.52 ) and has a domain ( apollo.bsigeo.net )
Installing Apollo using the server name when configuring the installation gives me a running apollo but if I access geospatial portal on the public IP/domain it won’t see the catalog and won't load any layer cause it's looking for apollo at http://apollo-2016/. I tried using the external IP and domain during configuration but got similar results only this time I’m not able to connect to the Apollo server even from the server itself.
Tried using a procedure similar to http://community.hexagongeospatial.com/t5/ERDAS-APOLLO-Q-A/Setup-Apollo-2016-with-public-facing-serv... since it seems logical that it will work in the same way but no success...
Is there anything I’m missing or any way I can set the proper configuration?
Any idea would be appreciated…
10-27-2016 08:22 AM
Based on the forum post @ http://community.hexagongeospatial.com/t5/ERDAS-APOLLO-Q-A/Setup-Apollo-2016-with-public-facing-serv..., you can try use the external server name during configuration wizard instead of the internal hostname.
Hope it helps & best
11-11-2016 11:41 AM
Hi guys... As I stated in the original post, I´ve already tried following the instructions in that thread and it didn´t work so the previous answer gives me nothing.
If I use the external server name during configuration I can not connect to the catalog at all (I get a 503 error), neither using Data Manager or Core console, same thing happens if I use the external IP.
Using Internal server name during configuration I can connect to the catalog from data manager and Apollo core console and Gospatial Potal sees the data published :
But If I try to add the data to the map I get an error:
The WMS acces request gives a 500 error.