Hexagon Geospatial

GeoMedia Q&A

Turn on suggestions Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Do you mean 

My Workflow tab and custom application commands

by Technical Evangelist on ‎09-17-2019 07:41 AM (218 Views)

Question

Why are my custom application commands still in My Workflow tab after using "Remove from My Workflow"  and exiting/saving the geoworkspace?  When I reopen the geoworkspace the custom application commands are still in My Workflow tab.

Answer

In GeoMedia Desktop tiers, Remove from My Workflow can remove custom application commands from the My Workflow tab Custom group, but only for the current GeoMedia session. When you restart GeoMedia any removed custom commands will again appear on the tab. Running the InstallAppCmd utility without the /r option removes the custom commands from the tab and GeoMedia.

Rate this article:
0 HexPoints
Did you find this article helpful? Yes No
2 Comments (2 New)
Hide Comments
Comments
by
on ‎02-25-2020 09:47 PM

Please can you explain how you add command in ribbon bar in geomedia ?

 

Thank You!

by Technical Evangelist
on ‎02-26-2020 04:48 AM

Rutu,

 

See the following Q & A articles or search Q & A for "ribbon bar".

 

Creating a Custom Ribbon in GeoMedia
https://community.hexagongeospatial.com/t5/GeoMedia-Q-A/Creating-a-Custom-Ribbon-in-GeoMedia/ta-p/33...

 

GeoMedia Logic used for Ribbon Bars, My Workflows and Key Board Short Cuts
https://community.hexagongeospatial.com/t5/GeoMedia-Q-A/GeoMedia-Logic-used-for-Ribbon-Bars-My-Workf...

 

Keith

Contributors