IMAGINE Discussions

Discuss and share topics of interest using ERDAS IMAGINE the world’s leading geospatial data authoring system.
Showing results for 
Search instead for 
Do you mean 
Occasional Contributor
Posts: 12
Registered: ‎07-10-2017

Autosync extremely slow

We're using Autosync from Imagine 2016 to rectify aerial photos.  Sometimes when placing control points it is painfully slow, taking over a minute to place the point after the mouse click.  Also, when the Automatic transformation calculation tool is turned on, small adjustments to control point locations, which usually recalculate almost immediately, also take a minute or two.  This situation will sometimes fix itself for no apparent reason and go back to taking mere seconds with no changes to data locations or Autosync project settings.  Has anyone else had this issue?  Does anyone know a cause or cure?


Thanks for any help.

Technical Evangelist
Posts: 627
Registered: ‎02-02-2016

Re: Autosync extremely slow

Hi Scott,


This issue will require further research by Hexagon Geospatial Support. We will assist you with this problem in support ticket 00021391.


Kind regards,


Stephen Bent

Hexagon Geospatial Support