07-03-2019 02:45 AM
Hi Community,
I'm Dwima.
Today I try to run my data in IMAGINE UAV follow steps from UAV Workflow Help. Here it is the setting of my data before running :
Then I run and the process is done. But if the run finished completely, then it’ll green in the process bar, but It is red bar. So, I checked in the directory where I saved the outputs, and there are nothing or blank.
What step that I missed here? Please advise. Sorry, I’m still learning. Thank you.
Regards,
Dwima.
Solved! Go to Solution.
07-08-2019 12:01 PM
Hi Dwima,
IMAGINE UAV is an add-on for ERDAS IMAGINE that is handled by our partner GEOSYSTEMS GmbH. Please use the link below to find more information about IMAGINE UAV on GEOSYSTEMS’ website.
IMAGINE UAV: https://www.geosystems.de/en/products/imagine-uav/
Kind regards,
Stephen Bent
Hexagon Geospatial Support
07-08-2019 09:46 PM
Hi Stephen,
OK Thank you for your information.
I contacted the technical support of geosystems and it was solved well.
Regards,
Dwima.
07-09-2019 08:08 AM
Hi Dwima,
Can you share how your problem was solved in case another Community member runs into a similar problem?
Thanks,
Stephen Bent
Hexagon Geospatial Support
07-09-2019 09:48 PM
Hi Stephen,
Sure, I contacted the geosystems technical support and I said, it's may be caused by the machine which is busy. Because I just re-run my workflow and it's running well.
Regards,
Dwima.