02-22-2018 05:01 AM
I want to set up an analyzer view on a vectorset with reports and boundaries.
Using following setting:
(both out of same vectorset)
shows all reports but only one single boundary (out of 20). (Screenshot: fa1
After that I checked if primary key is set proper on that layer - it is.
If I change settings to:
which means that I want to check if my boundaries are shown proper if I use them as element data, evry boundary is shown fine.
Any ideas/tipps/hints? Or is that a bug?
Solved! Go to Solution.
02-22-2018 06:55 AM
Feature Analyzer will determine if there is any feature data associated with a boundary record. If no feature data is associated, then the boundary geometry is removed from the display.
I've created a blacklog item to optonally allow displaying boundary features where no feature records are linked.