01-28-2019 02:08 PM
I am using spatial modeler to create segments and then converts them into a category or class shapefile, after that I want to merge specific segments based on class value
when I did that, shapefile contains ten attributes but none of them is related with the class
I think there are two options:
Is there any way to do that and automatically?
the idea is that in the end only the shapefile is revised and edited with the classes
Thanks so much!!
Solved! Go to Solution.
01-29-2019 05:35 AM
This post should provide some ideas of the different directions you could go with this:
Or you could check out the new Machine Learning capabilities:
Hope this helps.