WebGIS Discussions

Need a push in the right direction when configuring WebMap, Portal or SDI services? Looking for hints and tips, or just looking for Ideas and information? The WebGIS discussion board is where you start those discussions, connect and share information.
Showing results for 
Search instead for 
Do you mean 
Reply
Occasional Contributor
Posts: 7
Registered: ‎10-19-2015
Accepted Solution

Geospatial Portal layer presentation from WMS

My WMS service layers appear in the response message in this order:

Administrative

Communication

County_Landbase

 

But in the layers list in Portal, they appear "reversed"

County_Landbase

Communication

Administrative

 

Is this expected behavior of Portal?   Can I control this in any way?

 

thanks,

Staff
Posts: 1,127
Registered: ‎10-18-2015

Re: Geospatial Portal layer presentation from WMS

Hello Karen,


this is the expected behavior of many WMS clients. The GetCapabilities response is interpreted bottom top vs top bottom. The same happens in GeoMedia and the way the GetCapabilities document is filled in WebMap is consistent.

 

 

You can change the legend configuration just dragging and dropping them in the needed order or you can add them one by one in different themes keeping the order. Another possibility would be adding them programmatically using the SDK.

 

Best regards,

Stefano

Stefano Turcato
Presale Engineer
Hexagon Geospatial
Occasional Contributor
Posts: 7
Registered: ‎10-19-2015

Re: Geospatial Portal layer presentation from WMS

Thanks Stefano,   Yes, I know I can move them around but it could be many layers.    Just confirming that this is expected behavior.